IBM 4400-006 User Manual - Page 144
NetWare 4.x and 5.x- No PSERVER Connection, repowering the Ethernet Interface? In larger Novell
View all IBM 4400-006 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 144 highlights
Chapter 6 Novell Troubleshooting Tips NetWare 4.x and 5.x- No PSERVER Connection • Was the Ethernet Interface power cycled after the PCONSOLE steps were completed? This will make the print server boot up and realize which print queue and file server it needs to service. • Is the Ethernet Interface already servicing a queue on another file server? If so, it cannot service another file server at the same time. • When defining a new print server within PCONSOLE, did you use the correct name for the Ethernet Interface (e.g., M_071C1A)? By default, it only recognizes itself as "M_xxxxxx" where "xxxxxx" equals the last six digits of its Ethernet address found on the configuration printout. • When defining a new printer name within PCONSOLE, did you use a predefined destination/queue rather than a name of your own? By default, the Ethernet Interface only recognizes names like d1prn. All other names will be ignored by the device. • Is the Ethernet Interface in Bindery mode as seen under the list pserver output on the device? If servicing only a NetWare 4.x or 5.x file server, it must be set to handle Bindery services. The default setting is Bindery. • Is there an available NetWare user license for the Ethernet Interface to use while it acts as a PSERVER? Every PSERVER takes up one user license since it logs into the Novell file server. • Have you given the connection process some time after repowering the Ethernet Interface? In larger Novell environments, the file server identification and connection process can take several minutes. 144