IBM 4400-006 User Manual - Page 203
Configuring An AS/400 TCP/IP Interface With ADDTCPIFC, Configuring An Interface For Ethernet
View all IBM 4400-006 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 203 highlights
Configuring An AS/400 TCP/IP Interface With ADDTCPIFC 8. The next step depends on your AS/400 release. See "Configuring PSF/400 For IPDS On V3R7 Or V4R1" on page 205 to configure your printer. NOTE: When the IPDS feature is installed, the queue name 'd4prn' is not available. 9. Verify the printer is ON using the VFYCFG command. 10. Verify that TCP/IP has been started using the STRTCP command. 11. Test your configuration. See "Verifying The IPDS Configuration On AS/400" on page 219. 12. To share the printer on the network, verify that the necessary parameters have been set correctly. See "Sharing The AS/400 Printer On The Network" on page 220. 13. If you have problems, refer to "AS/400 Troubleshooting" on page 222. Configuring An AS/400 TCP/IP Interface With ADDTCPIFC NOTE: Do not enter the IP address of the Ethernet Interface. Do not set the AS/400 interface address to the same address as the Ethernet Interface IP address. Also, do not add the Ethernet Interface to the AS/400 TCP/IP interface list. Configuring An Interface For Ethernet ADDTCPIFC is used to add a TCP/IP interface to AS/400. This step configures the AS/400 for attachments to a TCP/IP network. 1. At the AS/400 command line, enter the following command: ADDTCPIFC INTNETADR ('9.99.15.188') LIND(ETHLAN) SUBNETMASK('255.255.255.0') 203