IBM 4400-006 User Manual - Page 190
Configuring The AS/400 For Printing, Setting Up Printing For ASCII Files
![]() |
View all IBM 4400-006 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 190 highlights
Chapter 9 Configuring The AS/400 For Printing Configuring The AS/400 For Printing To configure an AS/400 for printing, you must: • set up the printing capability, and • verify the setup with a print job. You will need the following information: SMART Remote Printer Queue name Set to 'd1prn' through 'd8prn'. NOTE: The Remote Printer Queue name must be in lowercase letters. Do not use "PASS." NOTE: When the IPDS feature is installed, the queue name 'dipdsprn' is not available. 'dipdsprn' is designated for d4prn, therefore do not use 'dipdsprn' for other queues. IP Address The IP address for the Ethernet Interface. Setting Up Printing For ASCII Files The next step is to set up the remote printing capability. There are two ways to do this: you can either specify the LPR parameters manually each time you send a file to the printer, or use Remote Writer and a remote output queue for automatic printing to the printer. To Use LPR Manually 1. Start TCP/IP, if it is not already running, by entering the command STRTCP. 2. At the AS/400 command line, enter LPR. 3. Figure 27 displays in bold the parameters you need to specify. 190
![](/manual_guide/products/ibm-4400006-user-manual-641ae0d/190.png)