IBM 4400-006 User Manual - Page 37

Ethernet Interface Verification 7. Put the printer online and wait for the "E-NET READY" message to display on the front panel. Placing the printer online starts the Ethernet Interface IP Address and Netmask update process. This process will take several minutes. NOTE: If you do not put the printer online, the setting you just entered will not take effect. Do not turn the printer off until you see the "E-NET READY" message. If you turn the printer off before the new values are written to memory in the Ethernet Interface adapter, you will need to repower the printer and repeat steps 6 and 7 above immediately. 8. Once the "E-NET READY" message displays, you may enter the Gateway Address by repeating front panel steps 6 and 7 above. This will ensure the correct Netmask becomes associated with the Gateway value you enter. From the front panel navigate to the Gateway Address and enter the appropriate value. You must press ENTER after inputting each segment of the Gateway Address. 9. Put the printer online and wait for the "E-NET READY" message to display on the front panel. 10. Enable the Power Saver mode if desired. Ethernet Interface Verification SMART Before performing the verification, you must connect the Ethernet Interface card to the network. 1. Print an E-NET test page to verify the settings you made. Follow the steps on page 35 for the Smart Ethernet card, or for the Basic Ethernet card, place DIP switch 2 in the down position prior to powering up the printer (see page 17). 2. Verify the Netmask is correct in two locations on the E-NET test page: • NETWORK INTERFACES • TCP/IP ROUTING TABLE 37