JVC GY-HM620U Instruction Manual - Page 80
Special Recording, Pre Rec, Clip Continuous Rec
![]() |
View all JVC GY-HM620U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 80 highlights
Shooting Special Recording Besides the normal recording mode, five special recording methods are available in this camera recorder. They are Pre Rec, Clip Continuous, Frame Rec, Interval Rec and Variable Frame. Select a mode from [Record Set] B [Rec Mode]. Memo : 0 Set using [Main Menu] B [System] B [Record Set] B [Rec Mode]. (A P120 [ Rec Mode ] ) Pre Rec 0 By setting the number of seconds in the [Pre Rec Time], you can start recording video and audio before actual recording starts based on the [Pre Rec Time] setting. 0 When starting actual recording while the camera recorder is in Recording Standby (STBYP) mode, you can start recording a few seconds earlier based on the [Pre Rec Time] setting. 0 Using Pre Rec allows you to record a complete event without missing the initial scenes even if you start the recording late. Memo : 0 Pre Rec Time can be set to "5sec", "10sec", or "15sec" in [Main Menu] B [System] B [Record Set] B [Rec Mode] B [Pre Rec Time]. 0 When the frame rate setting in [Main Menu] B [System] B [Record Set] B [Record Format] B [Frame & Bit Rate] is set to "XHQ", "15sec" cannot be selected. (A P120 [ Pre Rec Time ] ) 1 Set [Rec Mode] to "Pre Rec". (A P120 [ Rec Mode ] ) 0 Set [Main Menu] B [System] B [Record Set] B [Rec Mode] to "Pre Rec". 0 The display changes ("STBY" B "STBYP"). 2 Press the [REC] button to start recording in Pre Rec mode. 0 The display changes ("STBYP" B "RRECP") and the card slot status indicator lights up in red. 0 Press the [REC] button again to pause recording. The display changes ("RRECP" B "STBYP") and the card slot status indicator lights up in green. Caution : 0 When the interval between start and stop recording is short, "STBYP" may not be displayed immediately after recording is complete. "RRECP" B "STBYP" ("STBY" blinks in red) B "STBYP" is displayed. 0 When the SD card becomes full during recording, recording stops and "STOP" is displayed. 0 Video and audio before the above mentioned time may not be recorded after recording starts in the following cases. 0 Immediately after power on 0 Immediately after recording stops 0 Immediately after switching from Media mode to Camera mode 0 Immediately after setting [Rec Mode] 0 Immediately after the end of Clip Review 0 Immediately after changing file format 0 Immediately after changing video format Completed Clip (Recorded video and audio) Recording starts a number of seconds earlier based on the [Pre Rec Time] setting Press [REC] Press [REC] (Recording starts) (Recording stops) . Clip Continuous Rec 0 In normal recording, when the recording stops, the image, audio, and accompanying data from the start till the end of the recording are recorded as one "clip" on the SD card. 0 This mode allows you to consolidate several rounds of "startstop recording" into one clip. Example: In normal recording, three clips are generated as Recording 1, Recording 2, and Recording 3. However, recording in this mode generates only one clip. 80
![](/manual_guide/products/jvc-gyhm620u-instruction-manual-34f6e79/80.png)