Netgear FS728TLP Web Management User Guide - Page 188

ProSAFE FS526Tv2, FS726Tv2, and FS728TLP Smart Switches order. If a sequence number is already in use for the port or ports, the ACL replaces the existing ACL that uses the same sequence number. If you do not enter a number, the smart switch assigns a default sequence number automatically. 12. In the Port Selection Table section, click one or both of the orange bars: • PORT. Displays the physical ports. • LAG. Displays the link aggregation groups 1 through 8. (For more information, see Chapter 8, Configure LAGs and LAG Membership.) 13. To bind one or more ports or LAGs to the ACL, use one of the following methods: • Bind individual ports or LAGs to the IP ACL: a. Click the PORT or LAG orange bar. b. Below each selected orange bar, select one or more ports or LAGs by clicking the square below each port or LAG. (Clicking a second time removes the ports or LAGs from the binding.) • Bind all ports or LAGs to the IP ACL. In the orange bar, click the square next to PORT or LAG. All ports or LAGs are bound to the MAC ACL. (Clicking a second time removes all ports or LAGs from the binding.) 14. Click the Apply button. The settings are saved, and the ACL information is added to both the Interface Binding Status table and the IP Binding Table on the IP Binding Table screen (see View the IP ACL Binding Table on page 219). For information about how to change the rule or remove the rule, see the procedures at the end of Manage Basic IP ACL Rules on page 209. Use the ACL Wizard to Create an ACL Based on a Destination IP Address Before you can use the ACL Wizard to create an ACL that is based on a destination IP address, first create an IP ACL ID.  To create an IP ACL ID and use the ACL Wizard to configure a rule that is based on the source or destination IP address: 1. Select Security > ACL > Advanced > IP ACL. Manage Access Control Lists 188