Netgear FS728TLP Web Management User Guide - Page 252

ProSAFE FS526Tv2, FS726Tv2, and FS728TLP Smart Switches Field Description Multicast Packets Received The total number of good packets that the port or LAG received and that were directed to a multicast address. This number does not include packets directed to the broadcast address. Broadcast Packets Received The total number of good packets that the port or LAG received and that were directed to the broadcast address. This number does not include multicast packets. Total Packets Received with The total number of inbound packets that the port or LAG received and that MAC Errors contained errors, preventing the packets from being delivered to a higher-layer protocol. Jabbers Received The total number of packets that the port or LAG received and that were longer than 1518 octets (excluding framing bits, but including FCS octets) and that had either a bad Frame Check Sequence (FCS) with an integral number of octets (FCS error) or a bad FCS with a nonintegral number of octets (alignment error). Fragments Received Note: This definition of a jabber is different from the definition in IEEE 802.3, section 8.2.1.5 (10BASE5) and section 10.3.1.4 (10BASE2). These documents define a jabber as the condition in which any packet exceeds 20 ms. The allowed range to detect a jabber is between 20 ms and 150 ms. The total number of packets that the port or LAG received and that were less than 64 octets in length with ERROR CRC (excluding framing bits but including FCS octets). Undersize Received Rx FCS Errors The total number of packets that the port or LAG received and that were less than 64 octets in length with GOOD CRC (excluding framing bits but including FCS octets). The total number of packets that the port or LAG received and that had a length (excluding framing bits, but including FCS octets) of between 64 and 1518 octets, inclusive, but had a bad Frame Check Sequence (FCS) with an integral number of octets. 802.3x Pause Frames Received The total number of MAC control frames that the port or LAG received and that had an opcode indicating a pause operation. Note: This counter does not increment when the interface functions in half-duplex mode. Total Packets Transmitted (Octets) The total number of octets of data (including those in bad packets) that the port or LAG transmitted (excluding framing bits but including FCS octets). This number provides a reasonable estimate of the Ethernet egress utilization. Packets Transmitted 64 Octets The total number of packets (including bad packets) that the port or LAG transmitted and that were 64 octets in length (excluding framing bits but including FCS octets). Packets Transmitted 65-127 Octets The total number of packets (including bad packets) that the port or LAG transmitted and that were between 65 and 127 octets in length inclusive (excluding framing bits but including FCS octets). Monitor the Switch and Traffic 252