Oki MC770 MC770/780 User Guide - Advanced - Page 156

SETTING ITEMS 2 Set each option, and then press [OK]. 1 Setting recovery transmission You can set a period of time to retain original data in the memory for the recovery transmission function, or whether enabling or disabling this function. 1 Press [RECOVERY TX]. 2 DISCARD You can switch discard printing ON or OFF. With it being set to ON, if an original is up to 10 mm (0.4 inch) longer than the printing area, the part that exceeds the paper printing area is discarded. 3  Basic Guide DUPLEX PRINT 2 Press [ 24H] or [ 1H] to set the document-stored time, and then press [OK]. You can switch duplex printing ON or OFF. With it being set to ON, received documents are printed on both sides of paper. Memo 4 • Duplex printing is available only if the received fax sizes and resolution are the same. • When paper has run out during duplex printing, the rest of the documents are printed on another size paper. • When the received fax is printed on 2 sheets of paper because it exceeds the printing area, duplex printing is not available. • Documents received using the batch transmission function are printed on both sides of the paper as one 5 continuous document. Pay attention to the separation Note of the individual documents particularly those consisting of an odd number of pages. • Even when duplex printing is set to ON, the document printed using the reception forward function is printed on a single side of paper. • Duplex printing direction differs depending on the received document size, as shown in the figures below. • When the screen is returned to the one shown in step 1 above, make sure that an orange line is marked on [RECOVERY TX]. This line indicates that the recovery transmission function is ON. If you press [RECOVERY TX] again, the orange line disappears, that is, the function is OFF. 6 Received LG, LT, or A4-sized documents are printed so that they can be bound along the long edge of the SECURE RECEIVE direction. (Figure 1) Received ST, A5 or B5-sized documents are printed so that they can be bound along the short edge of the direction. (Figure 2) The SECURE RECEIVE function allows you to store received fax jobs in the equipment without printing them. With this function, you can prevent the leaking of confidential information 7 1 A 2 A in a fax received when no people are present in your office, such as nighttime or holidays, or when an unspecified number of people visit your office. The SECURE RECEIVE setting consists of a manual ON/OFF setting and a scheduled ON/OFF setting for each day of the week (WEEKLY SCHEDULE) by administrators. The SECURE RECEIVE function can be manually enabled/ REDUCTION disabled, or automatically enabled/disabled at a specified time and day of the week. You can switch RX reduction printing ON or OFF. With it being set to ON, if an original exceeds the printing area by more than 10 mm (0.4 inch), it is reduced by 90% of the original size when printing.  Basic Guide Note • If the equipment is being used in the High Security mode, the SECURE RECEIVE function is not available. - 156 -