Oki MC770 MC770/780 User Guide - Advanced - Page 257
On the POWER SAVE screen, press [AUTO, Setting the Auto Power Save mode
View all Oki MC770 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 257 highlights
Memo • If you want to clear an entered time, press the [CLEAR] button on the control panel. • If you want to put the equipment into the Sleep mode for an entire day, enter the same time in both the [ON] and [OFF] boxes. Example) When you enter "0:00" in both the [ON] and [OFF] boxes for [SUN], the equipment automatically goes into the Sleep mode at the [OFF] time specified for [SAT]. The Sleep mode is kept until the [ON] time specified for [MON] comes. • If you do not want to put the equipment into the Sleep mode for an entire day, make settings for the desired day of the week as follows: [ON]: 0:00 / [OFF]: 24:00 The equipment does not go into the Sleep mode for an entire day, which is activated by the weekly timer function. However, the equipment automatically goes into the Sleep mode according to the time value set for [Auto Sleep mode], if it is left inactive for a certain period of time. Setting the Auto Power Save mode 1 On the POWER SAVE screen, press [AUTO POWER SAVE]. The AUTO POWER SAVE screen is displayed. 2 Press the desired period of time (in minutes) that this equipment should wait before the Power Save mode is activated. SETTING ITEMS (ADMIN) 2 Specify the following items as required and complete the setting. Item name Description 1 SLEEP TIMER Press the desired period of time (in minutes) that this equipment should wait before the Sleep mode is activated. SLEEP MODE Select the AUTO, SLEEP, or POWER OFF mode after the specified [SLEEP TIMER] time. 2 Note • The equipment may not enter the Sleep mode at the set timing depending on its operating status. • The machine is not switched to the Sleep mode in the following cases: - A particular option is installed. (Wireless LAN module, e-BRIDGE ID Gate) - The IPsec function is enabled. 3 - IEEE 802.1X authentication is enabled. - IPv6 is enabled and the IPv6 address is set other than manually. - POP3 client setting is enabled and under any of the following conditions: (1) The scan rate is set to other than 0 minute. (2) A POP3 server address is entered. (3) An account name is entered. 4 - A particular network protocol is enabled. (AppleTalk, IPX/SPX) • Protocol settings for recovering this equipment from the Auto Sleep mode are made in the TopAccess administrator mode. For details, refer to the TopAccess Guide "Chapter 8: [Administration] Tab Page". • By default, the Power Save period is set to 1 min and the Sleep period is set to 1 min. 5 6 The Auto Power Save mode setting is completed, and you will be returned to the previous screen. Setting the Auto Sleep mode 1 On the POWER SAVE screen, press [AUTO SLEEP]. 7 The AUTO SLEEP screen is displayed. - 257 -