Oki MC770 MC770/780 User Guide - Advanced - Page 194
If the screen below appears, place another, original on the original glass and press
View all Oki MC770 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 194 highlights
USEFUL FUNCTIONS 4 Make the settings required for the selected scan function, and then press [OK]. • The required settings vary depending on the selected 1 scan function. For instructions on how to perform settings for each scan function, see the following sections: Basic Guide For instructions on how to scan your documents with Scan to e-Filing, refer to the e-Filing Guide. • Pressing [OK] on the screen for each scan function takes you back to the basic scan menu with the 2 selected function button marked with an orange line. 5 On the SCAN menu, select the second scan function that you want to use, and repeat step 4. 7 If the screen below appears, place another original on the original glass and press [SCAN] or the [START] button to continue scanning. To finish the job, press [JOB FINISH], followed by the [RESET] button. 3 6 4 On the SCAN menu, press [SCAN]. 5 Note 6 • You can set 2 scan functions at one time. Selecting 3 scan functions at one time is not allowed. • The WS Scan function cannot be selected with other scan functions. Memo • To clear the scan functions, select one and press 7 [RESET]. The screen on the touch panel returns to the basic scan menu and the selected button is cleared. • The above screen is not displayed under the following conditions: - You scan the original from the Reversing Automatic Document Feeder without pressing [CONTINUE] to scan additional originals. - A scan preview is displayed. • To cancel the operation, press [JOB CANCEL]. • To change the scan settings, press [SCAN SETTING]. P.181 "Changing Scan Settings" Note • When the equipment has scanned more than 1000 pages in a job, the "The number of originals exceeds the limits. Will you save stored originals?" message appears. If you want to save the scans, press [YES]. • When the temporary workspace is full on the equipment's hard disk, a message appears and the job is canceled. The available workspace can be viewed on the TopAccess [Device] tab. • If the number of jobs waiting to store scans in the equipment's hard disk exceeds 20, a message appears to indicate that the equipment's memory is full. In this case, wait a while until memory becomes available again or delete unnecessary jobs from [JOB STATUS]. Basic Guide - 194 -