Pioneer AVH-4100NEX Owner's Manual - Page 79
Installation - owner s manual
View all Pioneer AVH-4100NEX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 79 highlights
Connecting the rear display This product Yellow (V OUT) Rear audio output Mini pin plug cable (sold separately) RCA cables (sold separately) To audio inputs To video input Rear display with RCA input jacks (sold separately) ■■When using a rear display connected to rear video output WARNING NEVER install the rear display in a location that enables the driver to watch the video source while driving. This product's rear video output is for connection of a display to enable passengers in the rear seats to watch the video source. Installation Precautions before installation CAUTION Never install this product in places where, or in a manner that: - Could injure the driver or passengers if the vehicle stops suddenly. - May interfere with the driver's operation of the vehicle, such as on the floor in front of the driver's seat, or close to the steering wheel or shift lever. - To ensure proper installation, be sure to use the supplied parts in the manner specified. If any parts are not supplied with this product, use compatible parts in the manner specified after you have the parts' compatibility checked by your dealer. If parts other than supplied or compatible ones are used, they may damage internal parts of this product or they may work loose and the product may become detached. - Do not install this product where it may (i) obstruct the driver's vision, (ii) impair the performance of any of the vehicle's operating systems or safety features, including airbags, hazard lamp buttons or (iii) impair the driver's ability to safely operate the vehicle. - Never install this product in front of or next to the place in the dashboard, door, or pillar from which one of your vehicle's airbags would deploy. Please refer to your vehicle's owner's manual for reference to the deployment area of the frontal airbags. Before installing Consult with your nearest dealer if installation requires drilling holes or other modifications of the vehicle. Before making a final installation of this product, temporarily connect the wiring to confirm that the connections are correct and the system works properly. Do not install this product in a position where the opening of the LCD panel is obstructed by any obstacles, such as the shift lever. Before installing this product, be sure to leave sufficient space so that the LCD panel does not obstruct the shift lever when it is fully opened. This may cause interference with the shift lever, or a malfunction of the mechanism of this product. Installing this product ■■Installation notes Do not install this product in places subject to high temperatures or humidity, such as: Places close to a heater, vent or air conditioner. Places exposed to direct sunlight, such as on top of the dashboard. Places that may be exposed to rain, such as close to the door or on the vehicle's floor. Install this product horizontally on a surface within 0 to 30 degrees tolerance (within 5 degrees to the left or right). Improper installation of the unit with the surface tilted more than these tolerances increases the potential for errors in the vehicle's location display, and might otherwise cause reduced display performance. Chapter ■■Installation using the screw holes on the side of this product 32 English Fastening this product to the factory radio-mounting bracket. Position this product so that its screw holes are aligned with the screw holes of the bracket, and tighten the screws at three locations on each side. Use either the truss head screws (5 mm × 8 mm) or flush surface screws (5 mm × 9 mm), depending on the shape of the bracket's screw holes. If the pawl interferes with installation, you may bend it down out of the way. 1 30° When installing, to ensure proper heat dispersal when using this unit, make sure you leave ample space behind the rear panel and wrap any loose cables so they 3 are not blocking the vents. Leave ample space 5 cm 5 cm 2 1 Factory radio-mounting bracket 2 Dashboard or console 3 Truss head screw or flush surface screw Be sure to use the screws supplied with this product. 79 En