Pioneer AVIC-D1 Owner's Manual - Page 103

AV SUB. W, you can connect a rear speaker lead directly to a subwoofer without using an auxiliary amp. Initially, navigation unit is set for rear full-range speaker connection (REAR SP FULL). When rear output is connected to full range speakers (when REAR SP FULL is selected), you can connect the RCA subwoofer output to a subwoofer. In this case, you can select whether to use the subwoofer controller's (low pass filter, phase) built-in PREOUT SUB. W or the auxiliary PREOUT FULL. 1 Touch "REAR SP" in the INITIAL menu. 2 Touch "REAR SP" to switch the rear out- put setting. When no subwoofer is connected to the rear output, select FULL. When a subwoofer is connected to the rear output, select SUB. W. ❒ When the rear output setting is SUB. W, you cannot change the subwoofer controller. 3 Touch "PREOUT" to switch the sub- woofer output or non fading output. ❒ Even if you change this setting, there is no output unless you turn "NON FADING" or "SUB WOOFER" in the AUDIO menu "ON". ➲ Using non fading output ➞ Page 99 ➲ Using subwoofer output ➞ Page 99 ❒ If you change the subwoofer controller (REAR SP), the subwoofer output (SUB WOOFER) and non fading output (NON FADING) in the AUDIO menu return to the factory settings. ❒ Both rear speaker leads output and RCA rear output are switched simultaneously in this setting. Switching the muting/attenuation When the navigation outputs the guidance voice, or when a mute signal has been received from the yellow/black lead connected to the navigation unit (e.g. using a cellular telephone), the audio volume is muted or attenuated. This function is activated in the following condition: - When "MUTE" or "ATT" is selected in this setting. - When "On" is selected in "Voice Guidance" on "Mute Settings". ➲ Mute Settings ➞ Page 63 1 Touch "TEL/GUIDE" in the INITIAL menu. Each touch of the "TEL/GUIDE" changes the settings as follows: • MUTE - Muting • ATT - Attenuation • NORMAL - Volume does not change ❒ The sound is turned off, "MUTE" is dis- played and no audio adjustments are possible. ❒ The sound is attenuated, "ATT" is displayed and no audio adjustments, except volume control, are possible. ❒ Operation returns to normal when the phone connection (the mute signal on the yellow/black lead) is ended or when the navigation guidance is ended. ❒ Even when you receive a phone call, navigation voice guidance cannot be attenuated or muted. Use the Volume to control the navigation voice guidance volume. Initial Settings Chapter 8 Customizing the Audio Source Setting 101