Pioneer AVIC-D1 Owner's Manual - Page 63
Checking the connections of, leads and installation positions - replacement screen
UPC - 012562739496
View all Pioneer AVIC-D1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 63 highlights
NAVI ❒ When tires have been changed or chains fitted, turning on the Speed Pulse allows the system detects the fact that the tire diameter has changed, and automatically replaces the value for calculating distance. ❒ If the ND-PG1 is connected, the distance calculation value cannot be replaced automatically. (5) Speed Speed detected by the Navigation System is indicated. (This indication may be different from the actual speed of your vehicle, so please do not use this instead of the speedometer of your vehicle.) (6) Acceleration or deceleration/Rotational speed Acceleration or deceleration velocity of your vehicle is indicated. Also, rotational speed when your vehicle turns to left or right is shown. (7) Inclination Degree of slope of the street is indicated. To clear values... If you want to delete the learned results stored in "Distance", "Speed Pulse" or "Learning Status", touch the relevant result, then touch "Clear". ❒ The Navigation System can automatically use its sensor memory based on the outer dimensions of the tires. Checking the connections of leads and installation positions Check that leads are properly connected between the navigation unit and the vehicle. Please also check whether they are connected in the correct positions. 1 Touch "Settings" in the Main menu, then touch "Hardware Info". 2 Touch "Connection Status". The Connection Status screen appears. (1) (2) (3) (4) (5) (6) (7) (1) Speed Pulse The Speed Pulse value detected by the Navigation System is shown. "0" is shown while the vehicle is stationary. (2) GPS Antenna Indicates the connection status of the GPS antenna, the reception sensitivity, and from how many satellites the signal is received. If the signal is received correctly, "OK" is displayed. If reception is poor, "NOK" appears. (3) Installation Position The Installation position of the navigation unit is shown. If installed correctly, "OK" appears. Indicates whether the Installation position of the navigation unit is correct or not. When the navigation unit is installed at an extreme angle exceeding the limitation of the installing angle, "Incorrect angle" will be displayed. When the angle of the navigation unit has been changed, "Excessive vibration" will be displayed. (4) Parking Brake When the parking brake is applied, "On" is displayed. When the parking brake is released, "Off" is displayed. (5) Power Voltage The power supply (reference value) provided from the vehicle battery to the Navigation System is shown. If the voltage does not fall within the range of 11 to 15V, check that power cable connection is correct. (6) Illumination When the headlights or small lamps of a vehicle are on, "On" is displayed. (If the orange/ white lead is not connected, "Off" appears.) (7) Back Signal When the gear lever is shifted to "R", the signal switches to "High" or "Low". (Which of these is displayed depends on the vehicle.) Chapter 4 Editing the Navigation Utilities 61