Samsung SCD6040 User Manual (user Manual) (English, French) - Page 160

If these instructions do not solve your problem, contact your, nearest Samsung dealer or authorised

Page 160 highlights

ENGLISH Troubleshooting Dépannage FRANÇAIS Display CARD ERROR! NOT FORMATTED! Blinking Informs that... Slow Memory card is formatted by other device or has error in system folder Slow Memory card needs to be formatted Action Format the memory card using the camera menu Format the memory card using the camera menu ✤ If these instructions do not solve your problem, contact your nearest Samsung dealer or authorised service center/personnel. Symptom Possible Causes Measure No power is supplied. LCD monitor is blank. DATE/TIME is wrong. The power is not connected properly. The battery is dead. The battery is too cold. Viewfinder is on. Multi-AV cable is connected. Display option is turned off. The DATE/TIME is not set. The built-in clock battery has exhausted. Connect the AC adapter properly, page 27. Replace the dead battery pack . Warm up the battery or move to warmer place. Close the viewfinder. Remove the cable. Press the DISPLAY button to bring back OSD. Set the DATE/TIME, page 38. Replace the Li-ion battery for builtin clock, page 24. Cannot Record a video. Focus does not adjust automatically. Cassette tape will not load properly. The memory card will not load properly. Protection tab is set to "SAVE". Power Switch is set to PLAY. Power Switch is set to (CAMERA). Focus is set to manual mode. Recording was done in a dark place. Lens is covered with condensation. Cassette is in wrong position. The battery is exhausted. Memory card is in wrong position. Something fills in the memory card slot. Cancel the protection, page 48. Set the Power Switch to REC . Set the Mode Dial to (MOVIE) mode. Set focus to AUTO. Use strobe or lit the place. Clear the lens and check the focus. Insert the cassette tape properly, page 47. Charge the battery or use AC adapter. Insert the memory card properly, page 83. Clear the memory card slot 160 Affichage ERREUR CARTE! NON FORMATE! Clignotant Lent : Lent : donne les informations suivantes... La carte mémoire est formatée par un autre appareil ou comporte une erreur dans le dossier système La carte mémoire doit être formatée Handeling Formatez la carte mémoire à l'aide du menu de l'appareil photo Formatez la carte mémoire à l'aide du menu de l'appareil photo ✤ Si ces instructions n'apportent aucune solution à votre problème, contactez votre revendeur Samsung le plus proche ou un technicien qualifié. Symptôme Il n'y a pas d'alimentation Pas d'affichage à l'écran LCD DATE/HEURE est faux Impossibilité d'enregistrer une vidéo La mise au point ne se fait pas automatiquement. La cassette ne s'insère pas correctement. La carte mémoire ne s'insère pas correctement. Causes possibles L'alimentation n'est pas correcte La batterie est usée La batterie est trop froide Le viseur est activé. Le câble multi AV est connecté L'option d'affichage est désactivée La DATE et l'HEURE ne sont pas réglées La pile de l'horloge interne est vide. Le volet de protection est réglé sur «ENREGISTRER» Le sélecteur de mise sous tension est sur position «PLAY» Le sélecteur de mise sous tension est sur position (PHOTO ). La mise au point est réglée sur le mode manuel. L'enregistrement a été effectué dans un endroit sombre. La lentille est couverte de buée. La cassette est mal insérée. La batterie est vide. La carte mémoire est mal insérée. Quelque chose bouche le compartiment de la carte mémoire. Remède Connectez l'adaptateur CA correctement, voir page 27 Remplacez le bloc-batterie usé Réchauffez la batterie ou déplacezla dans un endroit plus chaud Fermez le viseur Retirez le câble Appuyez sur le bouton AFFICHER pour retrouver l'affichage à l'écran Réglage de la DATE et de l'HEURE , page 38 Remplacez la pile au ion-Li de l'horloge interne, voir page 24 Levez la protection, voir page 48 Placez le sélecteur de mise sous tension sur REC . Choisissez le mode (MOVIE ) à l'aide du Mode Dial . Réglez la mise au point sur AUTOMATIQUE Utilisez le stroboscope ou éclairez l'endroit Nettoyez la lentille et vérifiez la mise au point. Insérez la cassette correctement, voir page 47. Rechargez la batterie ou utilisez l'adaptateur CA. Insérez la carte mémoire correctement, voir page 83. Nettoyez le compartiment de la carte mémoire.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132
  • 133
  • 134
  • 135
  • 136
  • 137
  • 138
  • 139
  • 140
  • 141
  • 142
  • 143
  • 144
  • 145
  • 146
  • 147
  • 148
  • 149
  • 150
  • 151
  • 152
  • 153
  • 154
  • 155
  • 156
  • 157
  • 158
  • 159
  • 160
  • 161
  • 162
  • 163
  • 164
  • 165
  • 166
  • 167

Si ces instructions n
apportent aucune solution
à
votre probl
è
me, contactez
votre revendeur Samsung le plus proche ou un technicien qualifi
é
.
Il n
y a pas
d
alimentation
Pas d'affichage
à
l'
é
cran LCD
DATE/HEURE
<DATE/TIME>
est faux
Impossibilit
é
d
enregistrer
une vid
é
o
La mise au
point ne se fait
pas
automatique-
ment.
La cassette ne
s
ins
è
re pas
correctement.
La carte
m
é
moire ne
s
ins
è
re pas
correctement.
L
alimentation n
est pas correcte
La batterie est us
é
e
La batterie est trop froide
Le viseur est activ
é
.
Le c
â
ble multi AV est connect
é
L
option d
affichage est d
é
sactiv
é
e
La DATE et l
HEURE <DATE/TIME>
ne sont pas r
é
gl
é
es
La pile de l
horloge interne est vide.
Le volet de protection est r
é
gl
é
sur
«
ENREGISTRER
»
<
SAVE
>
Le s
é
lecteur de mise sous tension
est sur position
«
PLAY
»
<PLAY>
Le s
é
lecteur de mise sous tension est
sur position
(PHOTO <CAMERA>).
La mise au point est r
é
gl
é
e sur le
mode manuel.
L
enregistrement a
é
t
é
effectu
é
dans
un endroit sombre.
La lentille est couverte de bu
é
e.
La cassette est mal ins
é
r
é
e.
La batterie est vide.
La carte m
é
moire est mal ins
é
r
é
e.
Quelque chose bouche le
compartiment de la carte m
é
moire.
Symptôme
Causes possibles
Remède
Connectez l
adaptateur CA
correctement, voir page 27
Remplacez le bloc-batterie us
é
R
é
chauffez la batterie ou d
é
placez-
la dans un endroit plus chaud
Fermez le viseur
Retirez le c
â
ble
Appuyez sur le bouton AFFICHER
<DISPLAY> pour retrouver
l
affichage
à
l
’é
cran
R
é
glage de la DATE et de l
HEURE
<DATE/TIME>, page 38
Remplacez la pile au ion-Li de
l
horloge interne, voir page 24
Levez la protection, voir page 48
Placez le s
é
lecteur de mise sous
tension sur REC <REC>.
Choisissez le mode
(MOVIE
<FILM>)
à
l'aide du Mode Dial
<molette de s
é
lection>.
R
é
glez la mise au point sur
AUTOMATIQUE <AUTO>
Utilisez le stroboscope ou
é
clairez
l
endroit
Nettoyez la lentille et v
é
rifiez la
mise au point.
Ins
é
rez la cassette correctement,
voir page 47.
Rechargez la batterie ou utilisez
l
adaptateur CA.
Ins
é
rez la carte m
é
moire
correctement, voir page 83.
Nettoyez le compartiment de la
carte m
é
moire.
Lent :
Lent :
ERREUR CARTE!
<CARD ERROR!>
NON FORMATE!
<NOT
FORMATTED!>
La carte m
é
moire est
format
é
e par un autre appareil
ou comporte une erreur dans
le dossier syst
è
me
La carte m
é
moire doit
ê
tre
format
é
e
Formatez la carte
m
é
moire
à
l
aide du
menu de l
appareil photo
Formatez la carte
m
é
moire
à
l
aide du
menu de l
appareil photo
Affichage
Clignotant
donne les informations
suivantes…
Handeling
Dépannage
ENGLISH
FRANÇAIS
160
160
Troubleshooting
If these instructions do not solve your problem, contact your
nearest Samsung dealer or authorised service center/personnel.
No power is supplied.
LCD monitor is blank.
DATE/TIME is wrong.
Cannot Record a video.
Focus does not adjust
automatically.
Cassette tape will not
load properly.
The memory card will not
load properly.
The power is not
connected properly.
The battery is dead.
The battery is too cold.
Viewfinder is on.
Multi-AV cable is connected.
Display option is turned off.
The DATE/TIME is not set.
The built-in clock battery
has exhausted.
Protection tab is set to
SAVE
.
Power Switch is set to PLAY.
Power Switch is set to
(CAMERA).
Focus is set to manual mode.
Recording was done in a
dark place.
Lens is covered with
condensation.
Cassette is in wrong position.
The battery is exhausted.
Memory card is in wrong
position.
Something fills in the
memory card slot.
Symptom
Possible Causes
Measure
Connect the AC adapter properly,
page 27.
Replace the dead battery pack .
Warm up the battery or move to
warmer place.
Close the viewfinder.
Remove the cable.
Press the DISPLAY button to bring
back OSD.
Set the DATE/TIME, page 38.
Replace the Li-ion battery for built-
in clock, page 24.
Cancel the protection, page 48.
Set the Power Switch to REC .
Set the Mode Dial to
(MOVIE)
mode.
Set focus to AUTO.
Use strobe or lit the place.
Clear the lens and check the focus.
Insert the cassette tape properly,
page 47.
Charge the battery or use AC adapter.
Insert the memory card properly,
page 83.
Clear the memory card slot
Display
Blinking
Informs that…
Action
CARD ERROR!
NOT FORMATTED!
Slow
Slow
Format the memory card
using the camera menu
Format the memory card
using the camera menu
Memory card is formatted
by other device or has error
in system folder
Memory card needs to be
formatted