ZyXEL NBG2105 User Guide - Page 25
Setting Access Point Mode, Navigation Panel
View all ZyXEL NBG2105 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Figure 6 Access Point Mode Application Chapter 3 Operation Modes 3.4.1 Setting Access Point Mode Select Access Point Mode if your device bridges traffic between clients on the same network. To set Access Point mode: 1 Make sure the power LED is on (not blinking). 2 Slide the Operation Mode Switch to Router. See Section 1.8 on page 16. 3 The NBG2105 restarts after you slide the Operation Mode Switch. 4 In the Web Configuator, click Management > Operation, select AP and then click Apply Changes. 3.4.2 Navigation Panel Use the sub-menus on the navigation panel to configure NBG2105 features. NBG2105 User's Guide 25
Chapter 3 Operation Modes
NBG2105 User’s Guide
25
Figure 6
Access Point Mode Application
3.4.1
Setting Access Point Mode
Select Access Point Mode if your device bridges traffic between clients on the same network. To set
Access Point mode:
1
Make sure the power LED is on (not blinking).
2
Slide the Operation Mode Switch to
Router
. See
Section 1.8 on page 16
.
3
The NBG2105 restarts after you slide the Operation Mode Switch.
4
In the Web Configuator, click
Management > Operation
, select
AP
and then click
Apply
Changes
.
3.4.2
Navigation Panel
Use the sub-menus on the navigation panel to configure NBG2105 features.