Brother International MFC 8500 Service Manual - Page 96
through cutout Y provided in the support film as shown on the previous
UPC - 012502603832
View all Brother International MFC 8500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 96 highlights
Reassembling Notes • When connecting the power inlet to the low-voltage power supply PCB, insert the brown and blue lead wires into eyelets L and N in the PCB, respectively, and then solder those wires on the solder side of the PCB. • After setting the power inlet back into place, fold the grounding wire into two and route the fold through cutout "Y" provided in the support film as shown on the previous page. • When reinstalling the low-voltage power supply PCB, route the main-LV-engine harness through cutout "X" provided in the support film as shown on the previous page. IV - 55
IV
- 55
±
Reassembling Notes
•
When connecting the power inlet to the low-voltage power supply PCB, insert the brown and
blue lead wires into eyelets L and N in the PCB, respectively, and then solder those wires on the
solder side of the PCB.
•
After setting the power inlet back into place, fold the grounding wire into two and route the fold
through cutout "Y" provided in the support film as shown on the previous page.
•
When reinstalling the low-voltage power supply PCB, route the main-LV-engine harness through
cutout "X" provided in the support film as shown on the previous page.