D-Link DGS-3120-24TC Product Manual - Page 108

xStack® DGS-3120 Series Managed Switch Web UI Reference Guide MLD Snooping Settings Users can configure the settings for MLD snooping. To view the following window, click L2 Features > L2 Multicast Control > MLD Snooping > MLD Snooping Settings, as show below: Figure 4-54 MLD Snooping Settings window The fields that can be configured are described below: Parameter Description MLD Snooping State Click the radio buttons to enable or disable the MLD snooping state. Max Learning Entry Value Enter the maximum learning entry value. Click the Apply button to accept the changes made for each individual section. Click the Edit button to configure the MLD Snooping Parameters Settings for a specific entry. Click the Modify Router Port link to configure the MLD Snooping Router Port Settings for a specific entry. After clicking the Edit button, the following page will appear: Figure 4-55 MLD Snooping Parameters Settings window The fields that can be configured are described below: Parameter Description Query Interval Max Response Time Robustness Value Specify the amount of time in seconds between general query transmissions. The default setting is 125 seconds. The maximum time in seconds to wait for reports from listeners. The default setting is 10 seconds. Provides fine-tuning to allow for expected packet loss on a subnet. The value of the robustness variable is used in calculating the following MLD message intervals: Group listener interval - Amount of time that must pass before a multicast router 100