D-Link DGS-3120-24TC Product Manual - Page 39

xStack® DGS-3120 Series Managed Switch Web UI Reference Guide Figure 3-9 Interface Settings window (EI Mode Only) The fields that can be configured are described below: Parameter Description Interface Name Enter the name of the IP interface to search for. Click the Find button to locate a specific entry based on the information entered. Click the IPv4 Edit button to edit the IPv4 settings for the specific entry. Click the Add button to add a new entry based on the information entered. (EI Mode Only) Click the Delete All button to remove all the entries listed. (EI Mode Only) Click the IPv6 Edit button to edit the IPv6 settings for the specific entry. (EI Mode Only) Click the Delete button to remove the specific entry. (EI Mode Only) NOTE: To create IPv6 interfaces, the user has to create an IPv4 interface then edit it to IPv6. Click the Add button to see the following window. Figure 3-10 IPv4 Interface Settings window (EI Mode Only) The fields that can be configured are described below: Parameter Description IP Interface Name Enter the name of the IP interface being created. IPv4 Address Enter the IPv4 address used. Subnet Mask Enter the IPv4 subnet mask used. VLAN Name Enter the VLAN Name used. Interface Admin State Use the drop-down menu to enable or disable the Interface Admin State. Secondary Interface Tick the check box to use this Interface as a Secondary Interface. When the primary IP is not available, the VLAN will switch to the secondary interface. It will switch back when the primary IP was recovered. Click the Apply button to accept the changes made. Click the