HP Neoware c50 TeemTalk® 5.0 for Unix User's Guide - Page 191
Character Display Attributes, Key String Definition
View all HP Neoware c50 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 191 highlights
HP700/92 Emulation Key String Definition The second line of each f-key definition contains the character string that is to be displayed, executed, and/or transmitted to the host when the key or button is pressed. The string may contain alphanumeric characters, control characters, and explicit escape sequence characters entered when Display Functions mode is enabled by pressing F7 or the Display Functns button. The default f-key string begins with the characters EC which represent the escape code that is used to begin each escape sequence. The EC characters are displayed in the key definition line by pressing the Esc key or the keys Ctrl + [ together when Display Functions mode is enabled. Note that you must enter the entire escape sequence before disabling Display Functions mode (by pressing F7 again). When Display Functions is enabled, the Return key may be used to insert carriage return codes (CR) in the string. If Auto LF mode is selected in the Mode Selection function menu, Return will generate a line feed (LF) code as well as carriage return. To change an f-key/button string definition, use the Tab or Shift + Tab keys to move the cursor onto the second line (the line following LABEL definition for that key/ button) and type in the new definition which can consist of a maximum of 80 characters. When you have finished defining f-key/button strings, press the F9 key to exit the menu. To enable the new definitions and display the relevant functions on the buttons, press the F10 key. Note: The host may reset the f-key definitions to their default values if required by the application. Character Display Attributes The HP700/92 emulation incorporates various display attributes which can be enabled by host commands or from the keyboard by the user. These attributes are listed in the table below. When an attribute or set of attributes are enabled, they affect all subsequently displayed characters until an end attribute command or another attribute command is received, or the end of the line is reached. Attributes remain at the display location where they were enabled and will not move when characters are inserted or deleted. You can configure the f-keys and buttons so that they will enable these attributes when pressed. To do this, display the User Key Definition menu by pressing the keys Shift + F10 together. Use the Tab or Shift + Tab keys to position the cursor in the first field next to the number of the f-key to be defined and press F2 until the letter L for Local is displayed. Press Tab and type in the text that will appear in the display 12-15