HP Neoware c50 TeemTalk® 5.0 for Unix User's Guide - Page 253

Wyse Emulations 21 Wyse Emulations This chapter describes features of the Wyse WY-50, WY-50+ and WY-60 terminal emulations. Introduction The emulation of the Wyse WY-50, WY-50+ or WY-60 terminal is entered by displaying the Emulation Settings dialog box from the Settings menu and setting the Alpha Emulation option to Wyse 50, Wyse 50+ or Wyse 60. TeemTalk also supports the Wyse emulations of the TeleVideo 910+, 920 and 925, ADDS Viewpoint A2, and Hazeltine 1500 terminals, selectable via the same dialog box option. All the Wyse associated emulations are configured via the Wyse Settings dialog box which is described in the Setup Menus chapter. Note that some settings may not apply to the particular emulation currently running. Selecting a setting that is not applicable to the current emulation will cause TeemTalk to use the default setting for that emulation when the dialog box is exited. Display Format The display is divided into three areas by default: the status line, the data area, and the label line. At the top of the screen is the status line which is used to display information relating to the emulation and messages from the application. The following section describes the status messages that can be displayed by the emulation. The data area is where data entered from the keyboard or the application is displayed. The data area is set to 24 lines by 80 columns by default. The label line is displayed at the bottom of the screen when the data area is set to 24 or 42 lines. This is can be used to display messages or function key labels defined by the host. 21-1