HP Neoware c50 TeemTalk® 5.0 for Unix User's Guide - Page 308
Telnet Session, Initiate Telnet Session With Host, Host Telnet Port Number, Telnet Keepalive Messages
View all HP Neoware c50 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 308 highlights
Resources & Command Line Options Telnet Session Initiate Telnet Session With Host Resource: xteemx340*tnHost: hostname Command Line: -tnhost hostname Default Setting: Not applicable These commands enable you to cause TeemTalk to initiate a telnet session with the specified host. Most emulations work quite well in the standard TeemTalk environment when the telnet process provided with the workstation is used to make the connection to the remote host. However, in some block mode emulations, especially the Tandem 6530 and IBM 3270, the telnet process does not pass all the necessary information to TeemTalk. To overcome this, TeemTalk has its own inbuilt telnet driver so that precise control can be exercised over the information that TeemTalk receives and transmits. You must use the telnet facility provided by TeemTalk when using block mode emulations such as Tandem 6530 and IBM 3270. Host Telnet Port Number Resource: xteemx340*tnPort: number Command Line: -tnport number Default Setting: 23 These commands enable you to specify the number of your host's telnet port if it is different from the default port number 23. Telnet Keepalive Messages Resource: xteemx340*tnKeepalive: on/off Command Line: -tnkeepalive enabled +tnkeepalive disabled Default Setting: Enabled These commands allow you to enable or disable telnet keepalive messages when using the TeemTalk telnet driver. 25-16