HP Surestore 64 fw 05.01.00 and sw 07.01.00 - Director Product Manager - User - Page 124
Configuring Fabric Parameters, Con Fabric Parameters dialog box
View all HP Surestore 64 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 124 highlights
Configuring the Director Configuring Fabric Parameters Use procedures in this section to set parameters on the director for fabric operation through the Configure Fabric Parameters dialog box. These parameters are stored in NV-RAM on the director. 1. Verify that the director is set offline. For instructions, refer to the "Setting Director Online State" on page 81. Caution: Setting the director offline terminates all Fibre Channel connections. 2. Choose Configure > Operating Parameters > Fabric Parameters from the Product Manager window. The Configure Fabric Parameters dialog box displays, as shown in Figure 34. Figure 34: Configure Fabric Parameters dialog box 3. Use information under "Fabric Parameters" to change settings as required for parameters in this dialog box. 4. After you change settings, click Activate. 5. Back up the configuration data when you are finished configuring the director. 6. Set the director online. For instructions, see "Setting Director Online State" on page 81. 124 Director Product Manager User Guide