HP Surestore 64 fw 05.01.00 and sw 07.01.00 - Director Product Manager - User - Page 211
Product Manager, Product, Manager, Cannot save IPL
View all HP Surestore 64 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 211 highlights
Information and Error Messages Table 9: Product Manager Messages (Continued) Message Cannot run diagnostics on a port card that is not installed. Cannot run diagnostics while a device is logged-in to the port. Cannot save IPL configuration while active=saved is enabled. Cannot save port configuration. Cannot save SNMP configuration. Cannot set all ports to 1 Gb/sec due to speed restriction on some ports. Description Port diagnostics (loopback tests) cannot be performed on a port that does not have a small form factor (SFF) optical transceiver installed. Port diagnostics (internal loopback test) cannot be performed on a port while an attached Fibre Channel device is logged in. The user cannot save the IPL file while the active=saved property is set. The port configuration cannot be saved at the Product Manager application because the Ethernet link is down or busy. The director SNMP configuration cannot be saved at the Product Manager application because the Ethernet link is down or busy. Displays if you try to set ports to operate at 1 Gb/sec data speed through the Configure Ports dialog box and some ports do not support speed configuration. Action Install a transceiver in the port and perform diagnostics again. Ensure the device is logged out and perform diagnostics again. The FICON management server property, active=save, must be disabled for HAFM to save the IPL file. Retry the operation later. If the condition persists, contact the next level of support. Retry the operation later. If the condition persists, contact the next level of support. Replace ports that do not support speed configuration with those that do support more than one configuration. Director Product Manager User Guide 211