Motorola PHOTON Q 4G LTE PHOTON Q - User Guide - Page 112

2. Change the Roaming Mode option to Any GSM/UMTS. 3. Under GSM/UMTS Settings, touch Select network and select a wireless network that supports Sprint International GSM Data Roaming. If applicable, touch Network Operator and select a specific operator. Note: Be sure you have the Allow GSM Data option checked. Access Email and Data Services on CDMA Networks If data service is available on a CDMA network, then you only need to set the phone to CDMA; you will not need to select the specific carrier. Selecting a specific carrier is only necessary for providers on the GSM network. If your phone has automatically selected a GSM network while traveling, then you will need to set the phone to CDMA to access CDMA data services. (See Enable Global Roaming Mode.) Visit sprint.com/sww for a list of services available in each country. Status Messages You may receive status messages under certain conditions. Before contacting Sprint Worldwide Customer Support, note the message, numeric code, and the conditions under which it appeared. The following table lists and describes the status messages. Status Messages Number Not in Service User Not Available User Not Authorized Please Try Later Service Restricted Service Not Available Emergency Calls Only System Busy. Try Later Service Conflict Please Try Again Self Check Error Self Check Fail Message Description The number that you entered is not valid. The phone that you called is either busy, out-of-range, or turned off. Please try again later. The phone that you called is either busy, out-of-range, or turned off. Please try again later. This service is temporarily not available. Please try again later. Service may not be activated properly. Please contact Sprint Customer Service to report the issue for resolution. This feature is not available on the current network. Either the service is not activated properly or the current network is available for emergency calling only. Adjust your network settings to check for other available networks. If service is still not available after adjusting the settings, contact Sprint Customer Service to report the issue for resolution The system is experiencing heavy traffic. Please try again later. This service cannot be enabled because an incompatible service has already been turned on. An error occurred. Note the error code and try again. A fault was detected with your phone. If this error recurs, note the error and contact Sprint Customer Service. An operational fault was detected with your phone. Note the numeric code, turn your phone off, and contact Sprint Sprint Worldwide Wireless Service 102