Netgear WC7500-Wireless User Manual - Page 117

ProSAFE Wireless Controller 5. In the Syslog Settings section of the page, configure the settings as described in the following table. Setting Description Enable Syslog Enable the syslog settings using the Enable Syslog check box to forward system wide logs to an external syslog server or to save to a storage device such as a USB or SD card connected to the wireless controller. By default, the syslog settings are disabled. Log Level From the Log Level menu, select one of the following levels: • LOG_LEVEL_CRIT. Critical errors only are logged. • LOG_LEVEL_ERR. Noncritical errors and critical errors are logged. • LOG_LEVEL_WARN. Warnings, noncritical errors, and critical errors are logged. • LOG_LEVEL_NOTICE. Notifications, warnings, noncritical errors, and critical errors are logged. • LOG_LEVEL_INFO. Informational messages, notifications, warnings, noncritical errors, and critical errors are logged. Syslog Location Select the External radio button if your network includes a syslog server. Syslog Server IP Address Enter the IP address to which the wireless controller and managed access points send all syslogs, if the Enable Syslog check box is selected. Note: Before you configure the IP address of the syslog server on the wireless controller, make sure that you set up a syslog server (such as a computer running a syslog service) and that the syslog server is available on the network. Server Port Number Enter the number of the port at which your syslog server is configured to listen to requests. 6. Click the Apply button. Your settings are saved. Configure the System and Network Settings and Register the Licenses 117