Netgear WC7500-Wireless User Manual - Page 166

ProSAFE Wireless Controller 13. To designate an access point as a remote access point, from the Site menu, select Remote. By default, all discovered access points are designated as Local. The Remote and Local designations are for organization only. Note: The wireless controller cannot discover remote access points over a site-to-site VPN connection or behind a remote NAT router without a VPN connection. To use an access point as a remote access point over a site-to-site VPN connection or behind a remote NAT router without a VPN connection, you must preprovision the access point and send it to the remote site for installation. For remote access points, the maximin WAN delay period is 100 millisecond. 14. Either select individual access points to be added to the managed list or select all access points to be added to the managed list: • Select individual check boxes for discovered access points that you want to add to the managed list. • Select the check box in the upper right of the table heading to add all discovered access points to the managed list. 15. Click the Add button. Depending on the type of access points that were discovered, a page that lets you enter or ignore a login name and a password might display. 16. If necessary, enter the login name and password. The Managed AP List page displays. Because this page is wide, it is shown in the following two figures. Discover and Manage Access Points 166