Netgear WC7500-Wireless User Manual - Page 46

ProSAFE Wireless Controller Step Configuration Web Management Interface Path 5. When the access points are operating, open the Discovery Wizard to do the following: Access Point > Discovery Wizard 1. Specify the state of the access points. The state can be either factory default in a Layer 2 network or already installed and functioning in standalone mode. 2. Run the Discovery Wizard. 3. Select the access points that you want the wireless controller to manage and add them to the managed list. Note: By default, all access points are added to the basic group and all settings from the basic group (profile definition, client authentication, authentication settings, and WiFi QoS) are applied to the access points. Scenario Example 2: Advanced Network With VLANs and SSIDs The following sample scenario consists of an advanced network with a wireless controller, PoE switch, Layer 3 switch or router, access points, and several VLANs and SSIDs. The wireless controller system includes the following VLANs: • VLAN 1, the default untagged VLAN to access the wireless controller • VLAN 10, a tagged client VLAN • VLAN 20, another tagged client VLAN • VLAN 100, a tagged management VLAN Management VLAN 100 Ethernet traffic Client VLAN 10 Ethernet traffic Client VLAN 20 Ethernet traffic SSID 1 Client VLAN 10 Wireless controller PoE switch WNDAP360 Backend L3 switch or router Internet WNDAP360 SSID 2 Client VLAN 20 Figure 15. Example: Advanced network with VLANs and SSIDs System Planning and Deployment Scenarios 46