Dell EqualLogic PS6210XS EqualLogic Group Manager Administrator s Guide PS Ser - Page 354

for your system. These diagnostic reports are stored on both the FS Series and PS Series arrays. The PS Series diagnostic report can be emailed automatically to your Dell customer support representative. Due to the size of the FS Series diagnostic report, that diagnostic report can be stored only on the array. • Generate diagnostic reports only when your support representative instructs you to do so. • Change the default settings only if your support representative instructs you to do so. You can run reports for the following diagnostics: • PS Series-Run on individual controllers on each array. These reports are automatically generated and stored on the array and can be emailed to your Dell customer support representative. • FS Series-Run on all controllers. These NAS cluster diagnostic reports are automatically generated and stored on the array. Because of the size of these reports, they cannot be emailed to your Dell customer support representative, but can be retrieved by File Transfer Protocol (FTP) or Service Control Point (SCP). If you are troubleshooting a problem with a PS Series system and have SupportAssist enabled, SupportAssist might provide a more detailed diagnostic report on the system. Contact Dell Technical Support to find out if SupportAssist could help you. The FluidFS Diagnostic Tool provides a quick customer troubleshooting tool to determine any network or other issues. Customers should run this tool only when instructed to by support. After running this tool, customers should send the diagnostic logs to support. See the Dell EqualLogic Group Manager CLI Reference Guide for information about the tool. Add Diagnostic Contact Information You can configure your system or group to send system diagnostic information to Dell customer support and other email recipients. The group can send PS Series diagnostic information to the specified recipients using multiple email messages. You will need the following information: • SMTP IP addresses - SMTP server addresses are used in the listed order if the default server is not available. You can specify up to three addresses. The format for SMTP IP addresses is: 123.45.67.89. • Sender's email address - This address appears in the From field of the message sent. The format is: [email protected]. Generate and Email Diagnostic Reports If an issue arises that only Dell Technical Support can correct, your support representative might instruct you to collect encrypted diagnostic information from one or more group members. NOTE: • If you are troubleshooting a problem with a PS Series system and have SupportAssist enabled, SupportAssist might provide a more detailed diagnostic report on the system. Contact Dell Technical Support to find out if SupportAssist could help you. • If you want to make NAS cluster diagnostics available through FTP, you must enable FTP on the NAS cluster. To generate diagnostic reports on a system without NAS configured: 1. Expand Tools and click Diagnostic reports. The Welcome tab opens. 2. Click Next. The Getting Started tab opens. 3. If you are working with Dell support and have been assigned a case number, type that number in the Case Number field. If you have not contacted Dell Technical Support, leave this field blank. 4. Click Next. 5. Verify that all members are selected to be included in the diagnostic report. A member is selected if the Select checkbox for that member is checked. If your Dell Technical Support representative directed you to remove any member from the report, verify that the Select checkbox for that member is clear. 6. Click Next. 7. On the PS Series Diagnostics - Select Members tab, select the member to include in the report and click Next. 354 About Monitoring