Dell Force10 Z9000 FTOS Command Line Reference Guide for the Z9000 System FTOS - Page 1094

Example FTOS#show ip ospf 34 neighbor Neighbor ID Pri State Dead Time Address Interface Area 20.20.20.7 1 FULL/DR 00:00:32 182.10.10.3 Gi 0/0 0.0.0.2 192.10.10.2 1 FULL/DR 00:00:37 192.10.10.2 Gi 0/1 0.0.0.1 20.20.20.1 1 FULL/DROTHER00:00:36 192.10.10.4 Gi 0/1 0.0.0.1 FTOS# show ip ospf routes Display routes as calculated by OSPF and stored in OSPF RIB. C-Series, E-Series, S-Series, Z-Series, S4810 Syntax Parameters show ip ospf process-id routes process-id Enter the OSPF Process ID to show a specific process. If no Process ID is entered, command applies only to the first OSPF process. Defaults Command Modes none • EXEC • EXEC Privilege Command History Version 8.3.11.1 Version 8.3.7.0 Version 7.8.1.0 Version 7.6.1.0 Version 7.5.1.0 Introduced on the Z9000. Introduced on the S4810. Added support for Multi-Process OSPF. Introduced on the S-Series. Introduced on the C-Series and E-Series. Usage Information This command is useful in isolating routing problems between the OSPF and the RTM. For example, if a route is missing from the RTM/FIB but is visible from the display output of this command, the problem is with downloading the route to the RTM. This command has the following limitations: • The display output is sorted by prefixes; intra-area ECMP routes are not displayed together. • For Type 2 external routes, Type 1 cost is not displayed. Example FTOS#show ip ospf 100 route Prefix Cost Nexthop 1.1.1.1 1 0.0.0.0 3.3.3.3 2 13.0.0.3 13.0.0.0 1 0.0.0.0 150.150.150.0 2 13.0.0.3 172.30.1.0 2 13.0.0.3 FTOS# Interface Area Lo 0 0 Gi 0/47 1 Gi 0/47 0 Gi 0/47 - Gi 0/47 1 Type Intra-Area Intra-Area Intra-Area External Intra-Area 1094