Dell Force10 Z9000 FTOS Command Line Reference Guide for the Z9000 System FTOS - Page 269

seq Assign a sequence number to a deny or permit filter in a MAC access list while creating the filter. C-Series, E-Series, S-Series, Z-Series Syntax seq sequence-number {deny | permit} {any | mac-source-address [mac-source-address-mask]} [count [byte]] [log] [monitor] To remove this filter, use the no seq sequence-number command. Parameters sequencenumber deny permit any mac-sourceaddress mac-sourceaddress-mask count byte log monitor Enter a number between 0 to 65535. Enter the keyword deny to configure a filter to drop packets meeting this condition. Enter the keyword permit to configure a filter to forward packets meeting this criteria. Enter the keyword any to filter all packets. Enter a MAC address in nn:nn:nn:nn:nn:nn format. (OPTIONAL) Specify which bits in the MAC address must match. If no mask is specified, a mask of 00:00:00:00:00:00 is applied (in other words, the filter allows only MAC addresses that match). (OPTIONAL) Enter the keyword count to count packets the filter processes. (OPTIONAL) Enter the keyword byte to count bytes the filter processes. (OPTIONAL, E-Series only) Enter the keyword log to log the packets. (OPTIONAL) Enter the keyword monitor when the rule is describing the traffic that you want to monitor and the ACL in which you are creating the rule is applied to the monitored interface. NOTE: For more information, refer to the "Flow-based Monitoring" section in the Port Monitoring chapter of the FTOS Configuration Guide. Defaults Command Modes Command History Not configured CONFIGURATION-MAC ACCESS LIST-STANDARD Version 8.3.11.1 Version 8.1.1.0 Version 7.6.1.0 Version 7.5.1.0 Introduced on the Z9000. Introduced on the E-Series ExaScale. Introduced on the S-Series. Introduced on the C-Series. 269