Dell Force10 Z9000 FTOS Command Line Reference Guide for the Z9000 System FTOS - Page 1263

owner name Defaults Command Modes Command History As noted above. CONFIGURATION Version 8.3.11.1 Version 8.3.7.0 Version 7.6.1.0 Version 7.5.1.0 Version 6.1.1.0 (OPTIONAL) Enter the keyword owner followed by the name of the owner of this event. Introduced on the Z9000. Introduced on the S4810. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. rmon hc-alarm Set an alarm on any MIB object. C-Series, E-Series, S-Series, Z-Series, S4810 Syntax Parameters rmon hc-alarm number variable interval {delta | absolute} rising-threshold value event-number falling-threshold value event-number [owner string] To disable the alarm, use the no rmon hc-alarm number command. number variable interval delta absolute rising-threshold value eventnumber Enter the alarm integer number from 1 to 65535. The value must be unique in the RMON alarm table. The MIB object to monitor. The variable must be in the SNMP OID format; for example, 1.3.6.1.2.1.1.3 The object type must be a 64 bit integer. Time, in seconds, the alarm monitors the MIB variables; this is the alarmSampleType in the RMON alarm table. The range is 5 to 3600 seconds. Enter the keyword delta to test the change between MIB variables. This is the alarmSampleType in the RMON alarm table. Enter the keyword absolute to test each MIB variable directly. This is the alarmSampleType in the RMON alarm table. Enter the keywords rising-threshold followed by the value (64 bit) the rising-threshold alarm is either triggered or reset. Then enter the event-number to trigger when the rising threshold exceeds its limit. This value is the same as the alarmRisingEventIndex or alarmTable of the RMON MIB. If there is no corresponding risingthreshold event, the value is zero. 1263