Dell Force10 Z9000 FTOS Command Line Reference Guide for the Z9000 System FTOS - Page 907

26 Link Aggregation Control Protocol (LACP) This chapter contains commands for Dell Force10's implementation of the link aggregation control protocol (LACP) for creating dynamic link aggregation groups (LAGs)-known as "port-channels" in the Dell Force10 operating software [FTOS]. The LACP commands in this chapter are supported by FTOS on all E-Series, C-Series, S-Series, Z-Series, or S4810 Dell Force10 systems. NOTE: For static LAG commands, refer to Port Channel Commands in the Interfaces chapter), based on the standards specified in the IEEE 802.3 Carrier sense multiple access with collision detection (CSMA/CD) access method and physical layer specifications. NOTE: An FTOS option provides hitless dynamic LACP states (no noticeable impact to dynamic LACP states after an route processor module [RPM] failover) on the E-Series. For more information, refer to the Redundancy Protocol in the High Availability chapter. clear lacp counters Clear Port Channel counters. C-Series, E-Series, S-Series, Z-Series, S4810 Syntax Parameters Defaults Command Modes Command History clear lacp port-channel-number counters port-channelnumber Enter a port-channel number: For the C-Series and S-Series, the range is 1 to 128. For the E-Series, the range is 1 to 255 for TeraScale and 1 to 512 for ExaScale. Without a Port Channel specified, the command clears all Port Channel counters. • EXEC • EXEC Privilege Version 8.3.11.1 Version 8.3.7.0 Version 7.6.1.0 Version 7.5.1.0 Version 6.2.1.1 Introduced on the Z9000. Introduced on the S4810. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. Related Commands show lacp - displays the lacp configuration. 907