Dell Force10 Z9000 FTOS Command Line Reference Guide for the Z9000 System FTOS - Page 1476

Version 8.3.7.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.2.1.1 Introduced on the S4810. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. priority Specify a VRRP priority value for the VRRP group. This value is used by the VRRP protocol during the MASTER election process. C-Series, E-Series, S-Series, Z-Series, S4810 Syntax priority priority To return to the default value, use the no priority command. Parameters priority Enter a number as the priority. Enter 255 only if the router's virtual address is the same as the interface's primary IP address (that is, the router is the OWNER). The range is 1 to 255. The default is 100. Defaults Command Modes Command History 100 VRRP Version 8.3.11.1 Version 8.3.7.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.2.1.1 Introduced on the Z9000. Introduced on the S4810. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. Usage Information To guarantee that a VRRP group becomes MASTER, configure the VRRP group's virtual address with same IP address as the interface's primary IP address and change the priority of the VRRP group to 255. If you set the priority command to 255 and the virtual-address is not equal to the interface's primary IP address, an error message appears. show config View the non-default VRRP configuration. C-Series, E-Series, S-Series, Z-Series, S4810 Syntax show config [verbose] 1476