Dell Force10 Z9000 FTOS Command Line Reference Guide for the Z9000 System FTOS - Page 1441

show ntp associations Display the NTP master and peers. C-Series, E-Series, S-Series, Z-Series, S4810 Syntax Command Modes show ntp associations • EXEC • EXEC Privilege Command History Version 8.3.11.1 Version 8.3.7.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.1.1.0 Introduced on the Z9000. Introduced on the S4810. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. Usage Information The following describes the show ntp associations command shown in the Example below. Field (none) Description One or more of the following symbols could be displayed: • * means synchronized to this peer. • # means almost synchronized to this peer. • + means the peer was selected for possible synchronization. • - means the peer is a candidate for selection. • ~ means the peer is statically configured. remote ref clock st when poll reach delay offset Displays the remote IP address of the NTP peer. Displays the IP address of the remote peer's reference clock. Displays the peer's stratum, that is, the number of hops away from the external time source. A 16 in this column means the NTP peer cannot reach the time source. Displays the last time the switch received an NTP packet. Displays the polling interval (in seconds). Displays the reachability to the peer (in octal bitstream). Displays the time interval or delay for a packet to complete a roundtrip to the NTP time source (in milliseconds). Displays the relative time of the NTP peer's clock to the switch clock (in milliseconds). 1441