Dell Force10 Z9000 FTOS Command Line Reference Guide for the Z9000 System FTOS - Page 496

• match ipv6 route-source • set ipv6 next-hop If the route map is not configured, the default is deny (to drop all routes). Defaults Command Modes Command History Usage Information Related Commands Not configured. ROUTER BGPV6-ADDRESS FAMILY Version 8.2.1.0 Version 7.4.1.0 Introduced on the E-Series ExaScale. Introduced The E-Series software resolves the network address configured by the network command with the routes in the main routing table to ensure that the networks are reachable via nonBGP routes and non-default routes. redistribute - redistributes routes into BGP. network backdoor Specify this IGP route as the preferred route. C-Series, E-Series Syntax network ipv6-address prefix-length backdoor To remove a network, use the no network ipv6-address prefix-length backdoor command. Parameters ipv6-address prefix-length Enter the IPv6 address in the x:x:x:x::x format followed by the prefix length in the /x format. The r range is /0 to /128. NOTE: The :: notation specifies successive hexadecimal fields of zeros. Defaults Command Modes Command History Usage Information Not configured. ROUTER BGPV6-ADDRESS FAMILY Version 8.2.1.0 Version 7.4.1.0 Introduced on the E-Series ExaScale. Introduced Though FTOS does not generate a route due to backdoor config, there is an option for injecting/ sourcing a local route in presence of network backdoor config on a learned route. 496