Dell Force10 Z9000 FTOS Command Line Reference Guide for the Z9000 System FTOS - Page 131

Parameters Command Modes Command History Usage Information Related Commands conditional nvram-cfgchange Reload if the condition is true. A configuration change to the nvram requires a switch reload. You must select nvram-cfg-change to reload the switch. EXEC Privilege Version 9.1(0.0) Version 8.3.11.1 Version 7.6.1.0 Version 7.5.1.0 E-Series Added 'conditional' parameter. Introduced on the Z9000. Introduced on the S-Series. Introduced on the C-Series. Original command. If there is a change in the configuration, FTOS prompts you to save the new configuration. Or you can save your running configuration with the copy running-config command. For information related to the BMP reload options, refer to the Bare Metal Provisioning (BMP) chapter. Use the conditional parameter if any configuration changes made to the nvram, such as stackgroup and fanout configurations, must be saved. • reset - resets a line card, RPM, or a failed SFM (TeraScale and ExaScale). • reset stack-unit - resets any designated stack member except the management unit. reset Reset a line card, RPM, or a failed SFM (TeraScale only). C-Series, E-Series Syntax Parameters reset {linecard number [hard | power-cycle] | rpm number [hard | power-cycle] | sfm slot number} linecard number hard power-cycle Enter the keyword linecard and a number for the line card slot number. The C-Series range is 0 to 7. The E-Series range is 0 to 13 on the E1200/E1200i, 0 to 6 on the E600/E600i, and 0 to 5 on the E300. (Optional) Add the keyword hard or power-cycle (powercycle is C-Series only) to power cycle the line card. Enter the keyword hard to power cycle the line card. Enter the keyword power-cycle after upgrading a C-Series FPGA to cause the FPGA to be reprogrammed based on the contents of the FPGA PROM. 131