Dell Force10 Z9000 FTOS Command Line Reference Guide for the Z9000 System FTOS - Page 320

Defaults Command Modes Command History Usage Information Disabled EXEC Privilege Version 8.2.1.0 Version 7.6.1.0 Version 7.5.1.0 Version 7.4.1.0 Introduced on the E-Series ExaScale. Introduced on the C-Series. Added support for VLAN and port-channel interfaces on the E-Series. Introduced on the E-Series. Because BFD can potentially transmit 20 packets per interface, you must restrict debugging information. ip route bfd Enable BFD for all neighbors configured through static routes. C-Series, E-Series Syntax Parameters ip route bfd [interval interval min_rx min_rx multiplier value role {active | passive}] To disable BFD for all neighbors configured through static routes, use the no ip route bfd [interval interval min_rx min_rx multiplier value role {active | passive}] command. interval milliseconds min_rx milliseconds multiplier value role [active | passive] (OPTIONAL) Enter the keywords interval to specify non-default BFD session parameters beginning with the transmission interval. The range is 50 to 1000. The default is 100. Enter the keywords min_rx to specify the minimum rate at which the local system would like to receive control packets from the remote system. The range is 50 to 1000. The default is 100. Enter the keywords multiplier to specify the number of packets that must be missed in order to declare a session down. The range is 3 to 50. The default is 3. Enter the role that the local system assumes: • Active-The active system initiates the BFD session. Both systems can be active for the same session. • Passive-The passive system does not initiate a session. It only responds to a request for session initialization from the active system. The default is Active. Defaults See Parameters 320