Dell Force10 Z9000 FTOS Command Line Reference Guide for the Z9000 System FTOS - Page 827

Example Related Commands Column Heading Route Source Active Routes Non-active Routes ospf 100 Total 1388 active... Description Identifies how the route is configured in FTOS. Identifies the best route if a route is learned from two protocol sources. Identifies the back-up routes when a route is learned by two different protocols. If the best route or active route goes down, the non-active route becomes the best route. If routing protocols (OSPF, RIP) are configured and routes are advertised, then information on those routes is displayed. Displays the number of active and non-active routes and the memory usage of those routes. If there are no routes configured in the FTOS, this line does not appear. FTOS>show ip route summary Route Source Active Routes Non-active Routes connected 17 0 static 3 0 ospf 100 1368 2 Intra-area: 762 Inter-area: 1 External-1: 600 External-2: 5 Total 1388 2 Total 1388 active route(s) using 222440 bytes Total 2 non-active route(s) using 128 bytes FTOS> show ip route - displays information about the routes found in the switch. show ip traffic View IP, ICMP, UDP, TCP and ARP traffic statistics. C-Series, E-Series, S-Series, Z-Series, S4810 Syntax show ip traffic [all | cp | rp1 | rp2] NOTE: These options are supported only on the E-Series. Parameters all cp rp1 (OPTIONAL) Enter the keyword all to view statistics from all processors. If you do not enter a keyword, you also view all statistics from all processors. (OPTIONAL) Enter the keyword cp to view only statistics from the Control Processor. (OPTIONAL) Enter the keyword rp1 to view only the statistics from Route Processor 1. 827