Dell Force10 Z9000 FTOS Command Line Reference Guide for the Z9000 System FTOS - Page 1260

variable interval delta absolute rising-threshold value eventnumber falling-threshold value eventnumber owner string Defaults Command Modes Command History owner CONFIGURATION Version 8.3.11.1 Version 8.3.7.0 Version 7.6.1.0 Version 7.5.1.0 Version 6.1.1.0 Enter the MIB object to monitor. The variable must be in the SNMP OID format; for example, 1.3.6.1.2.1.1.3. The object type must be a 32 bit integer. Time, in seconds, the alarm monitors the MIB variables; this is the alarmSampleType in the RMON alarm table. The range is 5 to 3600 seconds. Enter the keyword delta to test the change between MIB variables. This is the alarmSampleType in the RMON alarm table. Enter the keyword absolute to test each MIB variable directly. This is the alarmSampleType in the RMON alarm table. Enter the keywords rising-threshold followed by the value (32 bit) the rising-threshold alarm is either triggered or reset. Then enter the event-number to trigger when the rising threshold exceeds its limit. This value is the same as the alarmRisingEventIndex or alarmTable of the RMON MIB. If there is no corresponding risingthreshold event, the value is zero. Enter the keywords falling-threshold followed by the value (32 bit) the falling-threshold alarm is either triggered or reset. Then enter the event-number to trigger when the falling threshold exceeds its limit. This value is the same as the alarmFallingEventIndex or the alarmTable of the RMON MIB. If there is no corresponding fallingthreshold event, the value is zero. (OPTIONAL) Enter the keyword owner followed by the owner name to specify an owner for the alarm. This is the alarmOwner object in the alarmTable of the RMON MIB. Introduced on the Z9000. Introduced on the S4810. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. 1260