Dell Force10 Z9000 FTOS Command Line Reference Guide for the Z9000 System FTOS - Page 57

3 File Management This chapter contains command line interface (CLI) commands needed to manage the configuration files as well as other file management commands. The commands in this chapter are supported by the Dell Force10 operating software (FTOS) on the E-Series, C-Series, SSeries, Z-Series, S4810 and S4820T platforms. boot config Set the location and name of the configuration file that is loaded at system start-up (or reload) instead of the default startup-configuration. C-Series, E-Series Syntax Parameters boot config {remote-first | rpm0 file-url | rpm1 file-url} remote-first rpm0 rpm1 file-url Enter the keywords remote-first to attempt to load the boot configuration files from a remote location. Enter the keywords rpm0 first to specify the local boot configuration file for route processor module (RPM) 0. Enter the keywords rpm1 first to specify the local boot configuration file for RPM 1. Enter the location information: • For a file on the internal Flash, enter flash:// followed by the filename. • For a file on the external Flash, enter slot0:// followed by the filename. Defaults Command Modes Command History Usage Information Not configured CONFIGURATION Version 7.5.1.0 E-Series Introduced on C-Series Original command To display these changes in the show bootvar command output, save the running configuration to the startup configuration (copy running-config startup-config or write). 57