Dell Force10 Z9000 FTOS Command Line Reference Guide for the Z9000 System FTOS - Page 811

show ip cam stack-unit Display CAM entries for an S-Series or Z-Series switch. S-Series, Z-Series Syntax Parameters show ip cam stack-unit id port-set pipe-number [ip-address mask [longer-prefixes] | summary] id pipe-number ip-address mask [longer-prefix] summary Enter the stack-unit ID. The unit ID range is 0 to 7 for S-Series. Enter the number of the Port-Pipe number. The S50n and S50V range is 0 to 1. The S25N, S25P, and S25V range is 0 to 0. (OPTIONAL) Enter the IP address and mask of a route to CAM entries for that route only. Enter the keywords longer-prefixes to view routes with a common prefix. (OPTIONAL) Enter the keyword summary to view a table listing route prefixes and the total number routes which can be entered in to CAM. Command Modes • EXEC • EXEC Privilege Command History Version 8.3.11.1 Version 7.7.1.0 Version 7.6.1.0 Introduced on the Z9000. Added support for up to seven stack members. Introduced on the S-Series. Usage Information The following describes the show ip cam command shown in the Example below. Field Destination EC Description Displays the destination route of the index. Displays the number of equal cost multipaths (ECMP) available for the default route for non-Jumbo line cards. For Jumbo line cards, displays 0,1 when ECMP is more than eight. CG Displays 0. V Displays a 1 if the entry is valid and a 0 otherwise. C V Id Mac Addr Displays the CPU bit. 1 indicates that a packet hitting this entry is forwarded to the CP or RP2, depending on Egress port. Displays the VLAN ID. If the entry is 0, the entry is not part of a VLAN. Displays the next-hop router's MAC address. 811