Dell Force10 Z9000 FTOS Command Line Reference Guide for the Z9000 System FTOS - Page 1481

Defaults Command Modes Command History Usage Information priority-cost (OPTIONAL) Enter a number as the amount to be subtracted from the priority value. The range is 1 to 254. The default is 10. priority cost = 10 VRRP Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.2.1.1 Introduced on the S-Series (S50 only). Introduced on the C-Series. Introduced on the E-Series. If the interface is disabled, the cost value is subtracted from the priority value and forces a new MASTER election if the priority value is lower than the priority value in the BACKUP virtual routers. virtual-address Configure up to 12 IP addresses of virtual routers in the VRRP group. You must set at least one virtual address for the VRRP group to start sending VRRP packets. C-Series, E-Series, S-Series, Z-Series, S4810 Syntax virtual-address ip-address1 [... ip-address12] To delete one or more virtual IP addresses, use the no virtual-address ipaddress1 [... ip-address12] command. Parameters ip-address1 ... ip-address12 Enter an IP address of the virtual router in dotted decimal format. The IP address must be on the same subnet as the interface's primary IP address. (OPTIONAL) Enter up to 11 additional IP addresses of virtual routers in dotted decimal format. Separate the IP addresses with a space. The IP addresses must be on the same subnet as the interface's primary IP address. Defaults Command Modes Command History Not configured. VRRP Version 8.3.11.1 Version 8.3.7.0 Version 7.6.1.0 Version 7.5.1.0 Version 7.4.1.0 pre-Version 6.2.1.1 Introduced on the Z9000. Introduced on the S4810. Introduced on the S-Series. Introduced on the C-Series. Introduced support for telnetting to the VRRP group IP address assigned using this command. Introduced on the E-Series. 1481