Dell Force10 Z9000 FTOS Command Line Reference Guide for the Z9000 System FTOS - Page 477

Related Commands Version 7.4.1.0 Introduced router bgp - Enter ROUTER mode on the switch. distance bgp Configure three administrative distances for routes. C-Series, E-Series Syntax distance bgp external-distance internal-distance local-distance To return to default values, use the no distance bgp command. Parameters external-distance internal-distance local-distance Enter a number to assign to routes learned from a neighbor external to the AS. The range is 1 to 255. The default is 20. Enter a number to assign to routes learned from a router within the AS. The range is 1 to 255. The default is 200. Enter a number to assign to routes learned from networks listed in the network command. The range is 1 to 255. The default is 200. Defaults • external-distance = 20 • internal-distance = 200 • local-distance = 200 Command Modes Command History ROUTER BGPV6-ADDRESS FAMILY Version 8.2.1.0 Version 7.4.1.0 Introduced on the E-Series ExaScale. Introduced Usage Information CAUTION: Dell Force10 recommends that you do not change the administrative distance of internal routes. Changing the administrative distances may cause routing table inconsistencies. The higher the administrative distance assigned to a route means that your confidence in that route is low. Routes assigned an administrative distance of 255 are not installed in the routing table. Routes from confederations are treated as internal BGP routes. ipv6 prefix-list Configure an IPv6 prefix list. Z-Series, S4810 Syntax ipv6 prefix-list prefix-list name 477