Dell Force10 Z9000 FTOS Command Line Reference Guide for the Z9000 System FTOS - Page 567

12 Debugging and Diagnostics The debugging and diagnostics commands are supported on the Dell Force10 C-Series, E-Series, S-Series, and Z-Series platforms. This chapter contains the following sections: • Diagnostics and Monitoring Commands • Offline Diagnostic Commands • Buffer Tuning Commands • Hardware Commands Diagnostics and Monitoring Commands The following section describes the diagnostics and monitoring commands. For similar commands, refer to the Control and Monitoring chapter. logging coredump Enable coredump. C-Series, E-Series, S-Series, Z-Series Syntax Parameters logging coredump {cp | linecard {number | all} | rps} cp linecard rps Enable coredump for the CP. Enable coredump for a linecard. Enable coredump for RP 1 and 2. Defaults Command Modes Command History The kernal coredump is enabled by default for RP 1 and 2 on the E-Series. The kernel coredump for CP and application coredump are disabled on all systems by default. CONFIGURATION Version 8.3.11.1 Version 7.7.1.0 Version 6.5.1.0 Version 6.1.1.0 Introduced on the Z9000. Restructured the command to accommodate core dumps for CP. Introduced on the C-Series and S-Series. Application coredump naming convention enhanced to include application. Introduced 567