Dell PowerEdge R750xa EMC Installation and Service Manual - Page 115
Installing the NVLink sponges, Removing the NVLink sponges
![]() |
View all Dell PowerEdge R750xa manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 115 highlights
Figure 113. Removing the NVLink sponges Next steps 1. Replace the NVLink sponges. Installing the NVLink sponges Prerequisites 1. Follow the safety guidelines listed in the Safety instructions. 2. Follow the procedure listed in Before working inside your system. 3. Remove the rear mounting front PERC module. NOTE: Observe the cable routing before disconnecting the cables. 4. NVLink sponges are required only for GPUs with NVLink bridges. Steps Holding the edges, align the NVLink sponge and insert between the drive cage and GPU riser module. Installing and removing system components 115
![](/manual_guide/products/dell-poweredge-r750xa-emc-installation-service-manual-e03ec2d/115.png)
Figure 113. Removing the NVLink sponges
Next steps
1.
Replace the NVLink sponges
.
Installing the NVLink sponges
Prerequisites
1.
Follow the safety guidelines listed in the
Safety instructions
.
2.
Follow the procedure listed in
Before working inside your system
.
3.
Remove the rear mounting front PERC module
.
NOTE:
Observe the cable routing before disconnecting the cables.
4.
NVLink sponges are required only for GPUs with NVLink bridges.
Steps
Holding the edges, align the NVLink sponge and insert between the drive cage and GPU riser module.
Installing and removing system components
115