Dell PowerEdge R750xa EMC Installation and Service Manual - Page 119
Removing the GPU riser module card holders, Prerequisites, Steps, Next steps
View all Dell PowerEdge R750xa manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 119 highlights
Removing the GPU riser module card holders Prerequisites 1. Follow the safety guidelines listed in the Safety instructions. 2. Follow the procedure listed in the Before working inside your system. 3. Remove the GPU riser module. NOTE: Your system has either half height (HH) or full height (FH) or without GPU card holder, which is based on the type of GPU card used. Steps Loosen the captive screw and pull out the HH or FH GPU card holder form the GPU riser module. Figure 119. Removing the HH card holder Figure 120. Removing the FH card holder Next steps 1. Replace the GPU riser module holders. Installing the GPU riser module card holders Prerequisites 1. Follow the safety guidelines listed in the Safety instructions. 2. Follow the procedure listed in the Before working inside your system. Installing and removing system components 119