Dell PowerEdge R750xa EMC Installation and Service Manual - Page 93
Removing the expansion card risers
View all Dell PowerEdge R750xa manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 93 highlights
Table 35. Config1-2. R2A + R3 paddle card + GPU riser module right with R1 paddle card + GPU riser module left with R4 paddle card (with NVbridge) (continued) Card type Slot priority Maximum number of cards Broadcom (OCP: 10Gb) Intergrated slot 1 Intel (OCP: 10Gb) Intergrated slot 1 QLogic (OCP: 10Gb) Intergrated slot 1 Broadcom (OCP: 1Gb) Intergrated slot 1 Intel (OCP: 1Gb) Intergrated slot 1 Foxconn (External Adapter) 3, 6 2 Foxconn (External Adapter) 3, 6 2 Inventec (BOSS 1.5) Intergrated slot 1 Removing the expansion card risers Prerequisites 1. Follow the safety guidelines listed in the Safety instructions. 2. Follow the procedure listed in the Before working inside your system. 3. Remove the air shroud. 4. If applicable, disconnect the cables from the expansion card or system board. NOTE: Only Riser 3 and Riser 2 are supported. Steps 1. Loosen the captive screws on the riser. 2. Press the blue release tab or blue button on the riser and holding the edges lift the expansion card riser from the riser connector on the system board. NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence. Installing and removing system components 93