Dell PowerEdge R750xa EMC Installation and Service Manual - Page 58
Installing a NVMe connector blank, Next steps, Prerequisites
![]() |
View all Dell PowerEdge R750xa manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
Next steps 1. Replace the NVMe connector blank. Installing a NVMe connector blank Prerequisites 1. Follow the safety guidelines listed in the Safety instructions. 2. Remove all drives. 3. Remove the drive backplane cover. 4. If required, remove the drive backplane CAUTION: NVMe connector blank is applicable for the system with x6 NVMe drive configuration. Steps 1. Align the NVMe connector blank with the guiding hole on the drive backplane. 2. Press the NVMe connector blank until clicks into place. Figure 53. Installing a NVMe connector blank Next steps 1. If removed, install the front bezel. 2. Install drive backplane. 3. Install all drives. 58 Installing and removing system components
![](/manual_guide/products/dell-poweredge-r750xa-emc-installation-service-manual-e03ec2d/58.png)
Next steps
1.
Replace the NVMe connector blank
.
Installing a NVMe connector blank
Prerequisites
1.
Follow the safety guidelines listed in the
Safety instructions
.
2.
Remove all drives
.
3.
Remove the drive backplane cover
.
4.
If required,
remove the drive backplane
CAUTION:
NVMe connector blank is applicable for the system with x6 NVMe drive configuration.
Steps
1.
Align the NVMe connector blank with the guiding hole on the drive backplane.
2.
Press the NVMe connector blank until clicks into place.
Figure 53. Installing a NVMe connector blank
Next steps
1.
If removed,
install the front bezel
.
2.
Install drive backplane
.
3.
Install all drives
.
58
Installing and removing system components