Dell PowerEdge R750xa EMC Installation and Service Manual - Page 127
Optional IDSDM module, Removing the IDSDM module
![]() |
View all Dell PowerEdge R750xa manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 127 highlights
Optional IDSDM module Removing the IDSDM module Prerequisites 1. Follow the safety guidelines listed in the Safety instructions. 2. Follow the procedure listed in the Before working inside your system. 3. If you are replacing the IDSDM module, remove the MicroSD cards. NOTE: Temporarily label each SD card with its corresponding slot number before removal. Reinstall the SD cards into the corresponding slots. Steps Holding the blue pull tab, lift the IDSDM module out of the system. Figure 131. Removing the IDSDM module Next steps 1. Replace the IDSDM module. Installing the IDSDM module Prerequisites 1. Follow the safety guidelines listed in the Safety instructions. 2. Follow the procedure listed in Before working inside your system. Steps 1. Locate the IDSDM connector on the system board. NOTE: For information on the exact location of IDSDM on system board, see System board jumpers and connector section. 2. Align IDSDM module with the connector on the system board. Installing and removing system components 127
![](/manual_guide/products/dell-poweredge-r750xa-emc-installation-service-manual-e03ec2d/127.png)