Dell PowerEdge R750xa EMC Installation and Service Manual - Page 129
Installing the MicroSD card, Next steps, Prerequisites, Internal SD Card Port, Steps
![]() |
View all Dell PowerEdge R750xa manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 129 highlights
Figure 133. Removing the MicroSD card Next steps 1. Replace the MicroSD cards. Installing the MicroSD card Prerequisites 1. Follow the safety guidelines listed in the Safety instructions. 2. Follow the procedure listed in Before working inside your system. NOTE: To use an MicroSD card with your system, ensure that the Internal SD Card Port is enabled in System Setup. NOTE: Ensure that you install the MicroSD cards into the same slots based on the labels you had marked on the cards during removal. Steps 1. Locate the MicroSD card slot on the IDSDM module. Orient the MicroSD card appropriately and insert the contact-pin end of the card into the slot. To locate IDSDM, see the System board jumpers and connectors section. NOTE: The slot is keyed to ensure correct insertion of the card. 2. Press the card into the slot to lock it into place. Installing and removing system components 129
![](/manual_guide/products/dell-poweredge-r750xa-emc-installation-service-manual-e03ec2d/129.png)